Smeg CWG400B, Manual

Page: 19 / 22

17
TOTAL PUMP-OUT AT THE END OF THE DAY
The dishwasher is able to perform an automatic cleaning cycle at the end of the day.
R
Press the pump-out button for about 2”, the LED
flashes and the pump-out and automatic tank cleaning
phase starts.
R
When pump-out is complete the appliance switches to
“
OFF
” status. (only 2 digits lit on the display)
After a total pump-out the filters should be cleaned as described above.
Never switch the dishwasher off with water in the tank; pump out first.
Resin regeneration (form models with water softener)
Once the number of washing cycles set during installation has been completed, as indicating that the resins will be
spent and regeneration is required, the LED above the
key flashes even during the cycle. If the appliance is to
be used for several more cycles, the resins should be regenerated as described below.
R
Press the key; the LED flashes and the
regeneration phase starts. It lasts about 13 minutes,
during which time the LED keeps flashing.
R
When the regeneration phase is complete, the
appliance performs a pump-out and automatic cleaning
cycle then switches to “
OFF
” status (only 2 digits lit on
the display).
If the user chooses not to perform regeneration, the appliance will carry it out
AUTOMATICALLY
during the total
pump-out phase, which will last
about 12’
, after which the appliance will switch off automatically.
Topping up with regenerating salt (for models with water softener)
Salt must be added when the “no salt” light ( ) appears on the display.
Top up with salt
when there is no water in the tank
to prevent washing water from getting into the water softener
device.
Caution: use only salt of the specific type, do not use cooking salt.
The salt tank has a capacity of about
1 kg of coarse-grained salt.
The salt reservoir is in the bottom of the tank. After removing the basket, undo the cap and pour the salt in using
the funnel supplied. Remove any salt residues around the opening before screwing the cap back on.