20
13 MALFUNCTIONS SHOWN ON THE DISPLAY
The dishwasher is able to identify a number of malfunctions and show them on the display.
The appearance of one of the following messages on the display indicates a malfunction which may be due to one
of the errors listed in the table below.
InFo 06
Drain partially blocked
InFo 07
Tank pressure switch reading off-scale
InFo 27
Low rinsing system efficiency
If the problem persists after the dishwasher has been switched off and back on, proceed as described below:
Err04
Tank temperature probe malfunction
Contact the After-Sales Service
Err05
Tank water filling malfunction
Check that the water intake tap is on and the dynamic
pressure in the intake system, inspect the water intake
filter and clean if necessary. If the problem persists,
contact the After-Sales Service.
Err06
Water pump-out malfunction
(dishwasher is left full of water)
Inspect the filters for dirt and check that the drain hose is
not blocked, bent or crushed.
Check that the drain pump is not blocked by dirt; proceed
as described in point “10.2 Periodic checks”.
If the problem persists, contact the After-Sales Service.
Err09
Tank water level too high
Err23
Boiler heating malfunction (does not heat
up)
Err24
Boiler temperature probe malfunction
Contact the After-Sales Service.
Err25
Boiler water filling malfunction
Check that the water intake tap is on and the dynamic
pressure in intake system, inspect water intake filter and
clean if necessary. If the problem persists, contact the
After-Sales Service.
Err26
Boiler emptying malfunction
Check that the rinsing spray arm nozzles are not fouled
If the problem persists, contact the After-Sales Service.
Err27
Boiler emptying malfunction – with tank full
Err28
Boiler heating malfunction (overheating)
Contact the After-Sales Service.
Summary of Contents for CWC600
Page 1: ...PROFESSIONAL DISHWASHER ...
