142541
Required tools: socket spanner nr. 8, screwdriver, torx 25
Caution! After unscrewing of before fi xing hinges, hold the door
to prevent it from falling and damaging.
1.
Remove upper hinge cover (keep it for eventual later use),
together with cover on the opposite side of the upper hinge
cover (on the opposite side you will insert the attached cover
during the assembly), and remove the cover on the opposite
side of the upper part of the door.
2.
Unscrew upper hinge screws and remove the door from the
bottom hinge.
3.
On the bottom side of the door unscrew the swing stopper
screws and remove the stopper (A). Keep this for later use.
Fix the attached stopper with its bearing on the opposite side
of the door.
4.
Unscrew the forced door closure system (B) and fi x it to the
opposite side of the door (certain models only).
5.
Tilt the appliance backward (max. 35°) to lean to the rear
side of the cabinet. Unscrew the leg support screws (C) - left
and right, and remove the leg support cover (D). Unscrew
and remove, then reciprocally replace the position of end
switch (E) and decorative peg (F) (for models with forced door
closing system). Place this on the opposite side. Unscrew
three screws fi xing the bottom hinge (keep this for possible
later use), and fi x the attached bottom hinge on the opposite
side.
6.
Proceed with the assembly procedure in opposite sequence.
Note:
In appliances with the handle along the entire height of the door,
the reverse door swing is not possible.
9
Reverse door swing