Instructions for the User
36
13.EXTRAORDINARY MAINTENANCE
Occasionally, the oven will require minor servicing procedures or the replacement of parts subject to
wear and tear, such as gaskets, light bulbs, etc. The specific operations for each procedure of this kind
are provided below.
Before carrying out any operations, disconnect the appliance from the electricity supply.
13.1 Changing the light bulb
Remove the protective cover
A
by unscrewing it clockwise; replace the bulb
B
with another of the same
type (25 W). Replace the protective cover
A
.
Use only light bulbs approved for ovens (T 300°C).
13.2 Removing the door
Fully open the door and turn the hinges
A
to the limit with
the aid of a thin-tip screwdriver.
Take hold of the two sides of the door with both hands
near to the hinges, close it to an angle of about 45° and
remove it.
To reassemble the door, fit the guide B into the oven
surround, replace the hinges A in the position shown here
and press them sharply down with a screwdriver or a
similar tool until you hear them snap into place.
13.3 Removing the gasket
To permit thorough cleaning of the oven, the seal may be removed. Before
removing the seal, take off the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown in the figure.
