16
- EN
Changing the programme after it has
started
You can use this feature to dry your clothes
under higher or lower temperatures after
your dryer has started.
For example;
1. Press and hold the “Start/Pause/Cancel”
button for about 3 seconds to “Cancel”
the programme in order to select “Extra
Dry” programme instead of “Iron Dry”
programme.
2. Select the “Extra Dry” programme by
rotating the programme selection button.
3. Press “Start/Pause/Cancel” button to
start the programme.
C
Press “Start/Pause/Cancel” button for
3 seconds to cancel the programme or
turn the programme selection knob in
any direction to end the programme while
the machine is running. Water tank and
filter cleaning warning lights turn on to
warn the user when the programme is
cancelled by pressing the “Start/Pause/
Cancel” button for 3 seconds. However,
the warning lights do not turn on when
the programme is cancelled by turning
the programme selection knob. Only the
drying light turns on and the machine
remains in hold until a new programme
is selected and the “Start/Pause/Cancel”
button is pressed. Child-proof lock of the
machine should not be active in order
to perform these two operations. If the
child-proof lock is active, deactivate it
before performing these operations.
Adding/removing laundry in standby
mode
In order to add or remove laundry after the
programme starts:
1. Press the “Start/Pause/Cancel” button to
switch the dryer to “Pause” mode. Drying
process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to
start the programme.
C
Any laundry added after the drying
process has started may cause the dried
clothes in the machine intermingle with
wet clothes and the result will be wet
laundry after the drying process is over.
C
Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing
of button while the programme is running.
The loading door and all buttons except
the “On/Off” button on the control panel
are deactivated when the child-proof lock is
active.
Press the “Start/Pause/Cancel” and
“Cancel audio warning” buttons
simultaneously for 3 seconds to activate the
child-press lock.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should be
deactivated. Press the same buttons for
3 sec. again to deactivate the child-proof
lock.
C
Child-proof lock is deactivated when the
machine is restarted by pressing the On/
Off button.
C
Press the relevant buttons for 3 seconds
to activate the child-proof lock. A long
beep will be heard and the child-proof
lock will be activated. A double beep
will be heard if you press any button
or turn the programme selection knob
while the child-proof lock is active. Press
the buttons for 3 seconds to deactivate
the child-proof lock. Single beep will
be heard and child-proof lock will be
deactivated.
