Instructions for the installer
41
8. OVEN INSTALLATION
The oven must be installed on a free-standing horizontal worktop. The distance
from the rear wall must allow easy access to the terminal board for connecting
the power supply cable. Installation must be carried out by a
qualified
technician
and in compliance with EC DIRECTIVES currently in force.
8.1
Electrical connection
Make sure the voltage and the cross-section of the power line match the
specifications indicated on the identification plate positioned on the side of the
oven.
Do not remove this plate for any reason
.
The oven is fitted with a three-core
H07RN-F
cable for operation at
220-240V
∼
and a power supply plug (on some models only).
The supplied cable is a three-core H07RN-F 3 x 1.5 mm
2
cable.
The power supply cable must be replaced by the manufacturer or by an
authorised service centre to prevent any risks.
The plug and wall-mounted socket must be of the same type (in accordance
with current regulations). Make sure that the power line is suitably earthed.
Avoid the use of adapters and shunts.
If the appliance is connected to the power supply network in a permanent
manner, install a multipolar switching device on the line, with contact opening
distance equal to or greater than
3 mm
located near the appliance and in an
easily reachable position.
ATTENTION:
if the phase voltage drops below 190V
∼
, the performance of the
oven may suffer, not due to the product itself.
The terminal indicated by this symbol links up parts that are normally earthed.
Connect the appliances properly using this terminal in order to make sure that
they are equipotential.
8.1.1 Safety thermostat
The oven is equipped with a safety device that triggers in case of serious
malfunction. To re-arm the safety device you must contact the technical
assistance service.
The manufacturer declines all responsibility
for damage to persons or things
caused by non-observance of the above prescriptions or by tampering with any
part of the appliance.
