Configuring the
Gateway’s mso Interface
160
SMCD3GNV Wireless Cable Modem Gateway User Manual
Disabling Port Forwarding
You can disable individual or all port-forwarding rules from the Port Forwarding menu.
To disable an individual port-forwarding rule, uncheck the rule in the
Active
column.
Although disabled, you can still use the buttons to the right of the checkbox to edit or
delete the rule. To enable the rule, check the checkbox in the
Active
column.
To disable all port-forwarding rules, click
Disabled
next to
Enable Port Forwarding
.
The
ADD PORT FORWARD
button becomes unavailable and all port forwarding rules
turn gray to show they are disabled. In addition, the buttons to the right of the
checkboxes become gray, preventing you from editing or deleting port-forwarding rules.
To enable all port-forwarding rules, click
Enabled
next to
Enable Port Forwarding
.
Enabling or Disabling Port Triggering
Using the Port Triggering menu, you can configure the Gateway to detect port triggers for
multiple-session applications and allow them to pass through the firewall. For special
applications, besides the initial communication session, there are multiple related sessions
created during the protocol communications. Normally, a normal treats the triggered
sessions as independent sessions and blocks them. However, the Gateway can co-relate
the triggered sessions with the initial session and group them together in the NAT session
table. As a result, you need only specify which protocol type and port number you want to
track, as well as some other related parameters. In this way, the Gateway can pass the
special applications according to the supplied information.
Assume, for example, that to use H.323 in a Net Meeting application, a local client starts a
session A to a remote host. The remote host uses session A to communicate with the local
host, but it also could initiate another session B back to the local host. Since there is only
session A recorded in the NAT session table when the local host starts the communication,
session B is treated as an illegal access from the outside and is blocked. Using the Special
Application menu, you can configure the Gateway to co-relate sessions A and B and
automatically open the port for the incoming session B.
To display the Port Triggering menu, click
Advanced > Port Triggering
in the menu bar.
Figure 94 shows an example of the menu.