Sentry 5000-32-IT Controller
Page 16 of 82
2.3.6 Digital Output
The Digital Output Board (
) provides connections for eight replaceable 8 amp relays. The three
position field connectors are located immediately below the socketed relay cubes. The cubes are labeled
as Relay 1 through Relay 8.
Because there are already eight fixed 5 amp relays on every stack the Digital Output board is useful for
either expanding the total number of relays in the controller or providing control relays for higher power
field devices. All the standard relays and the Digital Output control relays are programmable via Sentry
Commander logic processing. The board includes:
(1) Eight Digital Output field connectors to support addresses Relay1 through Relay 8
(2) Socketed, replaceable 8 amp relays corresponding to the field connectors
(3) Factory installed ribbon cable connection for power and inter-stack and SBC communication
Digital Output Stacks can be installed in any stack position in the controller, generally as Stack 2 or Stack
3. A maximum of two Digital Output Stacks are allowed per standard channel controller.
Figure 9: Digital Output Board
Summary of Contents for Sentry 5000-32-IT
