SMC Networks RSDQx12 series, Operation Manual

Page: 9 / 14

- 8 -
7-4. Absorbed energy adjustment
Absorbed energy is adjusted by a stroke change using the adjustment bolt.
(Cylinder is set for maximum absorbed energy at the time of shipment)
[Adjustment method] (See Fig. 7)
①
Loosen the set screw holding adjustment bolt in place (M4).
②
Turn the adjustment bolt so that the impact is reduced.
③
Tighten set screw to lock adjustment bolt in place.
(Tightening torque M4: 1.5N
・
m)
Adjustment amount
RSQ32 RSQ40,50
1.5mm 2mm
Fig. 7
8. Basic Circuit for Cylinder Operation
The basic circuit for operating the product with air filter, regulator, solenoid valve and speed controller is
shown in the Figure 8 and 9.
Fig. 8 Basic circuit of stopper cylinder (both double acting and double acting with spring)
Stopper
Cylinder
Speed
Controller
Solenoid
valve
Regulator Air filter
Air source
Set screw for
adjustment bolt
(M4).
Tool
：
Hexagon
wrench
：
Width across
flats 2mm
Adjustment bolt
Tool
：
Hexagon wrench
：
Width across flats 3mm
Absorbed energy
Adjustment bolt
Small
Large
Air source
Solenoid
valve
Adjustment
amount