- 9 -
2-5 Piping
1. Preparation before piping
Before piping is connected, it should be thoroughly blown out with air (flushing) or washed to remove chips,
cutting oil, and other debris from inside the pipe.
2. Winding of sealant tape
When screwing piping or fittings into ports, ensure that chips from the pipe threads or sealing material do
not enter the piping. Also, if sealant tape is used, leave 1.5 to 2 thread ridges exposed at the end of the
threads.
2-6 Lubrication
Caution
Magnet gripper is lubricating non-lube type.
These cylinders have been lubricated for life at the factory and can be used without any further lubrication.
However, in the event that it is additionally lubricated, be sure to use class 1 turbine oil (with no additives)
ISO VG320. Do not use machine oil or spindle oil. Stopping lubrication later on may lead to a malfunction
because the new lubricant will displace the original lubricant. Therefore, lubrication must be continued once
it has been started. If turbine oil is used, refer to the corresponding Safety Data Sheet (SDS).
2020-03-09 14:57
DJ927412
