LEJ-SMY72EN
Page 3 of 3
6 Maintenance - continued
6.2 Periodical Maintenance
Maintenance should be performed according to the table below:
Appearance
Check
Belt Check
Inspection before daily operation
Inspection every six months*
Inspection every 1,000km*
Inspection every 5 million cycles*
*
whichever of these occurs first.
Following any maintenance, always perform a system check. Do not
use the product if any error occurs, as safety cannot be assured if
caused by any un-intentional malfunction.
6.3 Appearance Check
The following items should be visually monitored and ensure that the
cylinder remains in good condition and there are no concerns
flagged;
・
Loose Screws,
・
Abnormal level of dust or dirt,
・
Visual flaws/faults,
・
Check the cable connections,
・
Abnormal noises or vibrations,
6.4 Belt Check
If one of the 6 conditions below are seen, do not continue operating
the cylinder, contact SMC immediately.
・
Tooth shaped canvas is worn out.
Canvas fibre becomes “fuzzy”, rubber is removed, and the fibre
gains a white colour. The lines of fibre become very unclear.
・
Peeling off or wearing of the side of the belt.
The corner of the belt becomes round and frayed, with threads
beginning to stick out.
・
Belt is partially cut.
Belt is partially cut. Foreign matter could be caught in the teeth and
cause flaws.
・
Vertical line of belt teeth.
Flaw which is made when the belt runs on the flange.
・
Rubber back of the belt is softened and sticky.
・
Crack on the back of the belt.
7 Limitations of Use
7.1 Limited warranty and Disclaimer/Compliance Requirements
Refer to Handling Precautions for SMC Products.
8 Product disposal
This product should not be disposed of as municipal waste. Check your
local regulations and guidelines to dispose of this product correctly, in
order to reduce the impact on human health and the environment.
9 Contacts
Refer to www.smcworld.com or www.smc.eu for contacts.
URL :
http// www.smcworld.com (Global) http// www.smceu.com (Europe)
'SMC Corporation, Akihabara UDX15F, 4-14-1, Sotokanda, Chiyoda-ku, Tokyo
101 0021
Specifications are subject to change without prior notice from the manufacturer.
©
2020
SMC Corporation All Rights Reserved.
Template DKP50047-F-085I
