Doc. no.IZ
*
-OMX0012
7
4) Keep within the specified ambient temperature range.
Ambient temperature range is 0 to 40
o
C. Do not use the product in locations where the ambient temperature
changes suddenly even within the specifications or if the temperature difference of the fluid relative to the
ambient temperature is large condensation may occur.
5) Environments to avoid
Avoid using and storing this product in the following environments since they may cause damage to this
product. These may cause an electric shock, fire, etc.
a. Areas where ambient temperature exceeds the operating temperature range.
b. Areas where ambient humidity exceeds the operating humidity range.
c. Areas where abrupt temperature changes may cause condensation.
d. Areas where corrosive gas, flammable gas or other volatile flammable substances are stored.
e. Areas where the product may be exposed to conductive powder such as iron powder or dust, oil mist,
salt, organic solvent, machining chips, particles or cutting oil (including water and any liquids), etc.
f. Paths of direct air flow, such as air conditioners.
g. Enclosed or poorly ventilated environment.
h. Locations which are exposed to direct sunlight or heat radiation.
i. Areas where strong electromagnetic noise is generated, such as strong electrical and magnetic fields
or supply voltage spikes.
j. Environment where static electricity is generated to the product.
k. Locations where strong high frequency is generated.
l. Locations which are subject to potential lightning strikes.
m. In an area where the product may receive direct impact or vibration.
n. Areas where the product may be subjected to forces or weight that could cause physical deformation.
6) Do not use air containing mist and/or dust.
Air containing mist and/or dust may cause performance deterioration, and reduce the maintenance cycle.
Install a dryer (IDF series), air filter (AF/AFF series), and/or mist separator (AFM/AM series) to obtain clean
compressed air (air quality of Class 2.4.3, 2.5.3, 2.6.3 or higher according to ISO 8573-1: 2010 (JIS
B8392-1:2012) is recommended for operation.
7) The product and AC adapter are not resistant to lightening surge.
8) Influence on the implantable medical equipment.
Electromagnetic waves emitted by this product may adversely affect implantable medical devices such as
implantable cardiac pacemakers and implantable defibrillators, such as malfunctions. For precautions
regarding the use of equipment or devices that may adversely affect performance, refer to the catalogue or
instruction manual of the device or equipment, or contact the manufacturer directly.
1) Perform maintenance regularly and clean the emitters.
- Check regularly that the product is not operating with
undetected failures.
- The maintenance must be carried out by an operator
who has sufficient knowledge and experience.
- If the product is used for an extended period of time
with foreign matter on the emitters, the static
neutralizing performance of the product will be reduced.
Clean the product regularly. (Emitter contamination
level is different depending on the installation
environment and supply pressure.)
- Clean the emitter and check the static neutralizing
performance when the maintenance LED is on.
- If the performance is not recovered after cleaning, it is possible that emitters are worn. Replace the emitter
assembly.
2) Cleaning or replacing the emitters should never be performed while the power supply or compressed
air supply are ON.
If the emitters are touched while the product is energized, this may cause an electric shock or accident.
3) Mount the emitter correctly.
If emitters are not correctly mounted, they may eject or release when compressed air is supplied.
Warning
Maintenance / Check
This product contains a high voltage
generation circuit. When performing
maintenance inspection, be sure to
confirm that the power supply to the
ionizer is turned off. Never disassemble
or modify the product, as this can cause
loss of product functionality, and there is
also a risk of electric shock and earth
leakage.
Danger High Voltage
