SMC Networks EliteConnect SMCE21011, User Manual, Page: 74 / 258

C
HAPTER
6
| Management Settings
Simple Network Management Protocol
– 74 –
SNMP
V
3 T
ARGETS
An SNMP v3 notification Target ID is specified by the SNMP v3 user, IP
address, and UDP port. A user-defined filter can also be assigned to
specific targets to limit the notifications received to specific MIB objects.
(Note that the filter must first be configured. See “SNMPv3 Notification
Filters” on page 74 .)
To configure a new notification receiver target, define the parameters and
select a filter, if required. Note that the SNMP v3 user name must first be
defined (See “SNMPv3 Users” on page 73 .)
Figure 34: SNMPv3 Targets
The following items are displayed on this page:
◆
Target ID — A user-defined name that identifies a receiver of
notifications. The access point supports up to 10 target IDs. (Maximum
length: 32 characters)
◆
IP Address — Specifies the IP address of the receiving management
station.
◆
UDP Port — The UDP port that is used on the receiving management
station for notification messages.
◆
SNMP User — The defined SNMP v3 user that is to receive notification
messages.
◆
Notification Filter — The name of a user-defined notification filter
that is applied to the target.
SNMP
V
3
N
OTIFICATION
F
ILTERS
SNMP v3 users can be configured to receive notification messages from the
access point. An SNMP Target ID is created that specifies the SNMP v3 user,
IP address, and UDP port. A user-defined notification filter can be created
so that specific notifications can be prevented from being sent to particular
targets.
The access point allows up to 10 notification filters to be created. Each
filter can be defined by up to 20 MIB subtree ID entries.