Making Network Connections
4-6
4
100 Mbps Fast Ethernet Collision Domain
10 Mbps Ethernet Collision Domain
Cable Labeling and Connection Records
When planning a network installation, it is essential to label the opposing ends of
cables and to record where each cable is connected. Doing so will enable you to
easily locate inter-connected devices, isolate faults and change your topology
without need for unnecessary time consumption.
To best manage the physical implementations of your network, follow these
guidelines:
• Clearly label the opposing ends of each cable.
• Using your building’s floor plans, draw a map of the location of all
network-connected equipment. For each piece of equipment, identify the devices
to which it is connected.
Table 4-3 Maximum 1000BASE-LX Fiber Optic Cable Length
Fiber Diameter
Fiber Bandwidth
Cable Length Range
Connector
9/125 micron single-mode fiber N/A
2 m - 5 km
(7 ft - 3.2 miles)
LC
Table 4-4 Maximum 1000BASE-ZX Fiber Optic Cable Length
Fiber Diameter
Fiber Bandwidth
Cable Length Range
Connector
9/125 micron single-mode fiber N/A
70* - 100 km
(43.5 - 62.1 miles)
LC
* For link spans exceeding 70 km, you may need to use premium single mode fiber or dispersion
shifted single mode fiber
Table 4-5 Maximum Fast Ethernet Cable Length
Type
Cable Type
Maximum Cable Length
Connector
100BASE-TX
Category 5 or better 100-ohm
UTP or STP
100 m (328 ft)
RJ-45
Table 4-6 Maximum Ethernet Cable Length
Type
Cable Type
Maximum Length
Connector
10BASE-T
Categories 3, 4, 5 or better
100-ohm UTP
100 m (328 ft)
RJ-45
Summary of Contents for 8124PL2
