![background image](http://html1.mh-extra.com/html/smc-networks/7208sbr/7208sbr_user-manual_1300195007.webp)
Page 4
Reset IP Button
(IP/Password)
If the Barricade's IP Address or password is lost, press and
release this button. The Barricade will beep once to indicate
the reset has occurred.
The Barricade password will be cleared, and its IP Address
set to the default value of 192.168.123.254, with a Network
Mask of 255.255.255.0
You can then connect to the Barricade and set the correct IP
Address and password.
WAN Port
Connect your ADSL or Cable modem here.
This Ethernet port supports 10BaseT and 100BaseT, and has
2 built-in LEDs. The amber LED (on the left) indicates a
100BaseT connection. The green LED (on the right) indi-
cates a 10BaseT connection.
Printer Port
Standard parallel printer port. A printer connected here
becomes a "network printer", and can be shared by Win-
dows and Macintosh users.
Serial Port
Standard serial port. Connect an analog modem or ISDN TA
here if you wish to provide shared Internet access to LAN
users via the serial port.
LEDs (Front Panel)
There are five (5) status LEDs on the front panel, as follows:
Ready
Normally ON.
This blinks during Startup or Shutdown, and turns OFF after the
shutdown is completed.
Error
(Amber)
Normally OFF.
However, it will be On during the power-on self test. Once the
self-test is completed, it will turn OFF. If it stays ON, there is a
hardware error.
During a software upgrade, both the Ready and Error LEDs
will blink.
Disk Full
Normally OFF.
Blinking indicates the disk is 98% full.
ON indicates the disk is completely full.
Disk
Flashes during normal operation, when the Hard Disk is ac-
cessed.
WAN
Flashes when data is transmitted or received via the WAN
(Internet Access) port