Figure 5 Alignment and fastening
of the
ROWOCON
®
sleeves
Figure 4
Arrangement of the nets (Illustration with inside
netting as additional element)
2x N1
1x N4 inside netting (if ordered)
1x N2
1x NH horizontal netting
4x N3
Figure 6 bring in of the rope ends
into the
ROWOCON
®
sleeves
Technical Information
smb
Carrantuohill
Seilspielgeräte GmbH Berlin
Page 3
Technikerstraße 6/8
15366 Hoppegarten
Germany
Phone: ++49 (0)3342 5 08 37 20
Fax: ++49 (0)3342 5 08 37 80
Assembling the surface netting
The
horizontal net (NH)
should be fitted first. Insert the rope ends on the slide side into the
ROWOCON
®
sleeves
as far as they will go
and fasten them with the
securing
screws
provided
(figure 5 and 6).
If individual
rope ends should insert only
with difficulty, you can help
yourself with an injection of
silicon
or
oil
in
the
ROWOCON
®
sleeves.
In no
case it is allowed to remove
the end sleeve of the rope!
Then fasten the opposite side,
using the hemp rope to provi-
sionally tighten the net, which
will
make
threading
and
screwing down easier.
The two remaining sides of
the net can then be screwed
down.
The
four
lower
triangular
nets (N3)
can then be fitted
similarly, followed by the
three
upper
trapeze nets (N1
and N2).
Caution:
If you bring in the rope ends into the ROWOCON
®
-sleeves and the following screwing
with the safety screw it must be sure that the rope ends are into the sleeves as far as
they will go. The safety screw must not screw through the aluminium sleeve at the end
of the rope (fig. 6). Otherwise the rope will be damaged.
