Operation and Maintenance Manual (DTR) iSWAY
®
Set of products
Version 1.8 of 2.2021
31
DA - with automatic canopy (only <V>=0.3 and 0.12 version)
<ADD>- accessories:
KE - flexible connector on the intake side
CP
–
air intake
UP - double air intake dampers
DS - roof for housing version with operating side <X> left or right
SS - installation on welded feet - horizontal installation
BF - installation on BIG FOOT - horizontal installation
KM - fixation with angle bars - horizontal installation
RS
–
installation on riveted frame
–
horizontal installation
PSW - installation on platform and levelling foot
* optional values - default values will be used if optional values are not specified
Order example:
iSWAY
–
FC
–
1.20 / KE, KM
As standard, the housing frame is painted in RAL 9010 (white) and the frame is filled with sandwich
slabs in RAL 9010 (white).
NOTE: When ordering more than six iSWAY-FC
®
units for a single facility, SMAY Sp. z o.o.
recommends the use of Devices Operation Status Monitoring (MSPU) with a Control Panel (TS),
allowing for integration and central monitoring of the air handling units.
8.2.2.
iSWAY-WFC
®
labelling
iSWAY- WFC-<W>-<U>-<Y>-<Dc>-<P><RAL>
<W> - the size/type of the device housing:
1.1
–
9500 [m
3
/h] unit capacity with available compression ratio of 130 Pa
1.5
–
12700 [m
3
/h] unit capacity with available compression ratio of 130 Pa
2.2
–
17000 [m
3
/h] unit capacity with available compression ratio of 140 Pa
3.0
–
27000 [m
3
/h] unit capacity with available compression ratio of 150 Pa
5.5
–
42000 [m
3
/h] unit capacity with available compression ratio of 140 Pa
<U> - location of SzA-FCK automation cabinet *
none = inside the building
Z
–
outside the building
<Y> - additional 24VDC outputs*
none = no additional 24VDC outputs
M - has an output for KSN vent, 24VDC power output for TSS, 24VDC output for peripheral device
<Dc>- additional pressure sensor*
none = no additional pressure sensor
PF
–
PMAC-F pressure sensor (as a standard, there is one pressure sensor in the MAC-FC
in the SzA-FCK automation cabinet)
<P> - finish (P and RAL applies to the CDH-K intake louver of the iSWAY-WFC)
AA - lamella profiles made of anodized aluminum, frame made of powder coated aluminum
