SmartPool NC71EU, Operation Manual

Page: 3 / 70

Congratulations on your purchase of the most technologically advanced automatic pool vacuum available today. The SmartPool Scrubber60 ™ is easy to use
and will make maintaining your pool affordable and effortless. Following these simple directions will insure that the SmartPool Scrubber60
™
will quickly and
efficiently clean your pool today and for many years to come.
DO NOT RUN THE CLEANER OUT OF THE WATER.
OPERATING THE CLEANER OUT OF THE WATER WILL DAMAGE THE MOTORS AND VOID THE WARRANTY
• Place the cleaner into the pool and if needed rock the cleaner side to side to release any trapped air. The cleaner will sink to the
bottom of the pool.
• Put enough of the blue cord into the water to assure that the cleaner can easily reach all areas of the pool.
• The cleaner will begin its cleaning program.
• The cleaner will automatically shut itself down after three hours.
• If a second cleaning is required or the unit is accidentally shut off, you should wait one minute before switching the unit on again.
IMPORTANT NOTE: During normal operation, the cleaner will appear to shut off for a few seconds. This is normal and part of the
pool cleaning program. The unit has multiple ways of cleaning the walls. It may climb to the top, scrub, then make a turn and drive
back down the wall to the bottom of the pool. It may also climb to the top, shut down for a few seconds, remove itself from the
wall, turn its pump motor on again, pushing itself down to the bottom of the pool away from the wall. It could also climb the wall,
scrub the waterline, turn its pump motor off, and float away from the wall down to the bottom. All of these variations have been
programmed into the cleaner and are designed to most quickly and efficiently clean your entire pool.
This unit has been designed to clean all areas of your pool. It will climb the walls, and occasionally break the surface. In the process
of climbing the wall it may stay on the surface and continue to operate from several seconds to a few minutes. This is normal
operation procedure and the cleaner will eventually make its way to the bottom to continue its cleaning. Since most of the dirt is
concentrated on the floor of the pool, the cleaner will spend the majority of its time on the floor.
INSTALLATION
• Place the power supply in an area that will allow the cleaner to cover all areas of the pool.
• Be sure to only plug the power supply into a GFI (ground fault interrupter) or ELI (earth leak interrupter) protected electrical outlet.
• Look at the power supply and check that the power supply switch is in the off position.
• Plug the power supply into the protected outlet.
• Plug in the connector from the cleaner into the power supply. The connector is keyed so that it will only plug into the power supply one way. Make sure that the plug is pushed all the
way onto the power supply. Slide the connector lock (strain relief) onto the connector and turn the connector lock clockwise until it is snug.