SmartPool NC71, Operation Manual

Page: 5 / 20

5
www.smartpool.com
1.1.A
• To reapply the filter bag, first turn it right side out. Next place the filter bag frame onto
the bottom lid being sure that the bag frame seats fully into the channel. Check the
seat of the filter onto the bottom lid (see Figure 7)
FIGURE 7
• Push the bag frame into the channel all the way around including the corners. The bag
is now installed.
• Pick up the bottom lid and turn it over so the bag hangs below it. Place the bottom lid
back into the cleaner being careful to feed the filter bag into the body of the cleaner.
MAKE SURE ALL FILTER MATERIAL IS INSIDE THE CLEANER OTHERWISE
THE LID WILL NOT CLOSE AND LATCH PROPERLY.
• Once the bottom lid is seated press it firmly into the cleaner. Gently pull on the bottom
lid to insure that it is properly locked in. The lid is now installed.
CABLE MAINTENANCE
In the course of using your Scrubber60, the cord may begin to coil. Excessive coiling
can lead to improper cleaning coverage of your pool.
• To uncoil the cord, it is best that the cable is wet.
• Place the cleaner on the ground as shown below.
• Be sure to use a clear area that will allow the cord to stretch out in a straight line.
• Pull the cable so it is off the ground
• Using your fingers, roll the cable in the opposite direction that it is coiled in.
• When straight, wrap cable for storage as shown below.
STORING THE CABLE
• Loosely loop the cable as shown below.
Hold the cord close to the cleaner.
Make a roughly two foot loop with
the cord as shown.
When making loop, roll the cable
slightly in a counter clockwise
manner to maintain form. DO NOT
WRAP THE CORD TIGHTLY AROUND
OBJECTS.
WINTER STORAGE
If temperatures will regularly be below 45 degrees Fahrenheit or 5 degrees Celsius, the
cleaner and power supply should be stored indoors.