34-SW-33-03
Smartline Wireless Antenna Replacement Kit
3
Step
– 1:
Honeywell recommends that the transmitter be removed from service and moved to a
clean area before servicing.
Step
– 2
: Loosen the M3 locking set screw on the display end-cap. See item 1 in Figure 1.
Unscrew and remove the front end cap.
Step
– 3:
Loosen the two screws on the electronic module. See items 2 in Figure 1.
Step
– 4:
Remove the electronic module from the transmitter body and disconnect the antenna
connector from CN2 connector on the electronic module. See item 3 in
Error! Reference source
not found.
.
Step
– 5:
Loosen the locking set screw at the antenna base. Unscrew the antenna from the
transmitter. Remove the antenna and its connector from the transmitter. See
Error! Reference
source not found.
.
Step
– 6:
Feed the new antenna’s connector through the antenna hole to the front of the
transmitter. Do not connect to electronic/display module yet. Lubricate with Silicone Grease such
as Dow Corning #55. Screw new antenna into transmitter body until finger-tight, then back off 180
degrees to permit adjustment later.
Step
– 7:
Attach antenna connector to CN2 connector on electronic/display module. See item 3
in
Error! Reference source not found.
.
Step
– 8:
Insert electronic/display module. Orient in the proper viewing orientation before
tightening two sensor compartment screws. See items 2 in
Error! Reference source not found.
.
Torque screws to 0,4
– 0,6 N-M (3.5 – 5.3 Lb-in).
Step
– 9:
Replace the front end cap. Honeywell recommends lubricating the front end cap O-ring
with a Silicone Grease such as Dow Corning #55 or equivalent before replacing the end cap.
Step
– 10:
Adjust antenna for best reception.
Don’t rotate antenna more than 180 degrees either
direction or you could twist and break the antenna wiring inside. Tighten the antenna locking set
screw.