105318, Russia, Moscow, Shcherbakovskaya str., b. 3. Ph.: (495)645-44-56 page
9
of
14
To eliminate this interference, change the code used by the remote control for STB.
Since there are two possible codes for STB, select the one that does not result in
undesirable interference with your TV.
To change the code, do the following steps:
1. Turn the STB on.
2. Press <POWER> and OK buttons and hold them for three seconds. When the LED
on remote control lights up, release the buttons. The remote control will switch to the
setting mode.
3. By default, the STB uses the code 1256, you can change the code to 1255. Enter the
code 1255. When you enter each digit, the LED will flash once.
4. If the code is entered correctly, the LED will flash twice. If the code is entered
incorrectly, the LED will flash once and the remote control will exit the setting mode.
Repeat steps 2
–4.
5. Try pressing the remote control button that causes undesirable interference with
another device. If the conflict is resolved, the code has been selected correctly.
6.8 Resetting the remote control
To reset the remote control:
1. Press and hold TV and OK buttons for 3 seconds. The LED on the remote control
will flash twice and the remote control will switch to the setup mode.
2. Enter the code 977. When you enter each digit, the LED will flash once. After that
the LED will blink four times, and the settings will be reset to default.
7
First start
When you switch on the STB for the first time, make sure that the STB is connected to a
managed IPTV network. The box will start downloading the latest version of the
software. Updating may take a few minutes. Do not disconnect the STB from power
supply and from the Internet before the updating is complete. After finishing the STB will
reboot automatically.
8
Troubleshooting
Problem
Possible reason
Solution
No picture
1. TV is not turned on
1. Turn on your TV
The screen
displays "No
signal"
1. STB is not
connected to the
mains supply.
2. STB is turned off.
3. TV is set to the
1. Connect STB to the mains supply.
2. Turn STB on by using its remote
control.
3. Use TV remote control to select the
