SmarTire Systems Inc.
Tire Monitoring System Reference Manual
6/20/2000 Page 31 of 56
This manual is under review by SmarTire – DO NOT ISSUE
Tire Rotation
After a tire rotation the receiver needs to be reconfigured
to accept existing tire ID numbers from the new locations.
The color code on the transmitter and valve correspond to
a sensor number
•
To choose this mode press the TIRE button when the tire
rotation icon is displayed
•
The tire outline indicates the installed sensors. The
selected tire location is filled-in. Use the TIRE button to
scroll to the desired tire location.
•
Press the MODE button to select it for editing. A number
representing each sensor is shown (e.g. a 2 corresponds to
sensor #2). Press the TIRE or MODE button to increase
or decrease the value respectively.
•
Press the SET button when the number representing the
desired sensor is achieved. This returns the display to the
tire selection menu. Scroll to a different tire location and
edit the sensor numbers. When all the changes are done,
press the SET button to save and exit this mode.
(ID 1 programmed in two
locations)
•
If more than one tire location contain the same sensor
number, the display will prompt an error with the
conflicting tires filled in and the associated sensor
number.
•
Press SET to return the tire selection menu and make
necessary corrections.
NOTE:
After removing a sensor from the system using the Learn mode (see Diagnostic Modes below),
the sensor numbers may be changed.
