SmartGyro Ziro, User Manual

Page: 31 / 86

Note that the approximate charging time is between 4-5 hours. Do not
leave the product charging once the light of the adapter has changed to
green or overcharge the battery for more than 3 hours.
IMPORTANT:
a) The load will be approximately 4-5 hours.
c) Do not overload the unit, as this will shorten the life of your battery and
its charger.
Tips to keep in mind when loading
- Load preferably in places away from flammable products.
- Monitor and control the loading period (which does not exceed the
recommended period).
- Use only the original charger.
- Do not leave the skate loading at night.
- If the skate has been exposed to high temperatures, wait and check
that it is not hot before putting it back on.
- For the charging procedure it is important that the skate is switched off
and that there is no accessory connected, as if it is not possible for
one of the sensors to remain activated and the battery to overheat.
- When the charger LED goes from red to green, it is when the smart-
Gyro is charged.
- Can not be charged with the ignition or working.
smartgyro.es
12
smartgyro.es
30
Charging the smartGyro
Make sure that your smartGyro's charger is in optimal condition. Check
that there is no dust or dirt in the connector and if so, clean it and make
sure it is dry.
Always use the original charger provided with the product and connect it
correctly to the device (through the charging port) and to a power outlet.
It is important that you always use the charger that comes with your
smartGyro, otherwise the device may fail and may not be covered by the
warranty. Once the product is loaded, it will take approximately two or
three hours to complete the charge.
When the LED light turns green, it means that the product is fully
charged. It is important that at that time, I desco
immediately negate the network adapter so that it stops charging. The life
of the battery will be affected by the battery charging time, never exceed
and extend the life of your battery.
Ziro- Manual