HMU8-860 ATS Remote Monitoring Controller User Manual Page 9 of 50
4.2
DISPLAY INTERFACE AND OPERTION
There are 5 interfaces of the monitoring module, namely homepage, detailed information, alarm,
event log and about. Transfer them through the key icon in the page switch bar.
4.2.1
HOMEPAGE DISPLAY
Fig. 2 – Homepage Display Interface
The incoming status area on the homepage can display S1/S2 line voltage, current, frequency,
power status and load power, ATS status, genset status, etc..
Table 5 – Display Area Description
Display Area
Description
Custom
Description
Character 1
Display HAT860 custome description character 1.
Custom
Description
Character 2
Display HAT860 custome description character 2.
Alarm Information Display
Area
Red light flashes when there are communication failure and fault alarm,
yellow light flashes when there is warning alarm;
Green light indicates that communication is normal.
Time and Date
Display real-time clock of master control module.
Incoming Status Area
Display power electric parameters, power status, load power, ATS close
status and genset status;
Power icon is shown in green when the power is normal, otherwise it is
gray;
It is shown in green when ATS and load breaker are available, otherwise
it is gray.
