SmartElex L293D Manual Download Page 4

Page: 4 / 5

Steps to bind Transmitter and receiver :-



ON-Remote (Transmitter) side

First, you have to connect the NRF Module. Otherwise status LED
BLINK Continuously.

Press switch 7(Binding Switch) and hold.

Then press the reset button for 5sec and release.

Now release switch 7(Binding Switch).

Status LED will start blinking. It means remote is in binding mode and
searching for the receiver.

Summary of Contents for L293D

Page 1: ...1 SmartElex Wireless Remote Control Motor Driver ...

Page 4: ...onnect the NRF Module Otherwise status LED BLINK Continuously 2 Press switch 7 Binding Switch and hold 3 Then press the reset button for 5sec and release 4 Now release switch 7 Binding Switch 5 Status LED will start blinking It means remote is in binding mode and searching for the receiver ...

Page 5: ...et button for 5sec and release 4 Now release Binding switch S 5 Status LED will start blinking It means remote in binding mode and searching for the transmitter 6 After sometime Receiver side status led blink fast frequency of led blinking change which means remote and receiver bind Now reset both remote and receiver by pressing the reset button 7 Now Ready To Drive ...