NB40F3UX – NB40S2UX – NB40LP2UX - NB40LPS2UX
REV 01 – Dec. 2019 - ENGLISH
NUBI 4.0
AVAILABLE MODELS
Model
Power Supply
PIR
NB40F3UX
10-15VDC <0,1mA
YES
NB40S2UX
10-15VDC <0,1mA
NO
NB40LP2UX
Lithium battery 3,6V
YES
NB40LPS2UX
Lithium battery 3,6V
NO
Thank you for purchasing NUBI 4.0, the intelligent smoke
screen security device able to be connected to any burglar
alarm system in new or existing systems.
OPERATIONAL OVERVIEW
NUBI 4.0 is an accessory for anti-theft systems which,
under certain conditions, activates the smoke capsule
housed inside. The capsule is packaged and supplied
separately. NUBI 4.0 must be connected to an burglar
alarm control unit via its inputs and outputs.
Activating the smoke capsule does not require any over-
current from the power source, since the necessary energy
has already been stored by the motherboard.
The XAFER S25 smoke capsule efficiently protects
volumes up to 100 m
3
. The smoke generated uses
pyrotechnic technology and incense; it is not classified as
harmful to human health. After use, the room must be
ventilated before staying there.
NUBI 4.0 is activated through 3 inputs, one of which to
control the immediate emission of smoke (
override input
),
while the other two create a more complex logic which,
when present, also includes the use of the internal infrared
sensor.
The polarity of the inputs can be easily configured using
the DIP switches.
NUBI 4.0 also has three outputs, one for tampering, one
for alarm and one for anomaly. The logic of the outputs can
be inverted using the DIP switches.
Devices equipped with an infrared sensor also have the
possibility to change the default behavior thanks to a
special configuration function that must always be
performed via the DIP switches.
An optional internal siren (NBSR01) can be housed inside
the box and connected to the dedicated connector on the
motherboard.
An optional accessory (NBTMPX) is available for
advanced tamper protection which contains sensors for
vibrations, heat, proximity and antifoam.
The smoke capsule works only once, the smoke emission,
when activated, can no longer be interrupted.
The replacement of the smoke capsule is very simple,
each replacement capsule is equipped with an electronic
card at the end of the wires to be easily connected to the
appropriate motherboard connector.
See our website: https://www.smarteksrl.it to check the
availability of this manual in other languages.
INSTALLATION
NUBI 4.0 can be easily installed on the
wall or even in a corner at a height
between 150 and 250 cm.
WARNING
Do not insert any obstacle at a distance
of less than 1.5 meters from the smoke
outlet hole.
The best performance is achieved when
the jet of smoke coming out from NUBI 4.0
directly hits the floor, in this way the smoke
will cool and spread better.
After opening the top cover, remove the motherboard to fix
the lower part of the box on the wall.
1
Motherboard rails
2
Cabling wire buttonhole
3
Internal siren fixing spacers
4
Internal siren sound outlet hole
5
Device fixing holes
6
Smoke cartridge supports