Longo Touch Screen LTS-1.PC2
4.6 Select and start the SCADA application
On Win CE Touch Screen loaded application always starts, as there is no editor on the CE device.
Changes can be made using (developer) PC with installed Movicon and then copied to the SD card.
When starting Movicon the pop-up for application selection will appear, if path/file-name defined in
MovCE.boot is not found.
Selected application will then start.
4.7 Stopping the SCADA application
Normally SCADA application on CE touch panel can be stopped using
File
menu on the top of the
screen. In case of FULL SCREEN mode, user can not access menu, nor the taskbar. In this case
stopping command should be included in SCADA application (responsibility of the developer).
Violent way to stop the application is to remove SD card and restart the Touch Screen using reset
button on the back/top (marked
RST on circuit board
).
4.8 Preventing the application from starting
In case when application is using FULL SCREEN, user can not access Movicon menu, nor Win CE
taskbar to stop the application. In that case there are basically three possible solutions:
1.
To put command for stopping Movicon inside SCADA application, for instance as a
button, possibly password protected.
2.
Changing path/file-name in
MovCE.boot
file using SD card reader.
3.
Changing the name of the SCADA application folder (using SD card reader), so
Movicon can't find application specified in
MovCE.boot
to auto-start with.
4.9 Configuring and using VNC server
To configure VNC server choose
Start
→
Run
from the taskbar.
•
Select
Browse
and then point to
•
\Storage Card\VNC\vncconfig.exe.
Click
OK
to start Configuration utility. Configure VNC server.
To configure IP settings of Touch Panel choose:
•
Start Settings Network and Dial-up
→
→
from the taskbar and then
•
double click on the
DM9CE1
icon.
•
Set LAN adapter IP settings.
Also set network/firewall/internet access settings to access touch screen from the internet.
Start VNC server by choosing
Start
→
Run
from the taskbar.
•
Select
Browse
and then point to
\Storage Card\VNC\WINVNC.exe.
Note: It is also possible to start VNC server through SCADA application, e.g. triggered with touch of
the “start VNC”button on admin page.
6
