USER’S MANUAL PAGE 26
TECH-5000P
USING THE Air Pump
•
Connect the air hose to the air pump by screwing the hose into
the end of the
hose (part A in figure 4), do not use protective cap (part B in
figure 4) for screwing as it is only for the protection of overheat.
Air Pump. When screwing, use main body of the
•
Connect the other end of the air hose to the valve stem of the
balls including soccer, basketballs and footballs.
NOTE:
bursts and check after each burst by feel or with a calibrated
measuring device to determine accurate pressure. Pressure
required for most sports balls is too low for accurate reading on
tool gauge.
•
Power on the air pump (choose an option mentioned in previous
section).
•
The manufacturer preset pressure is 30 PSI and this air pump
has memory function.
The gauge will indicate unites and value.
•
Press “SET” button to choose the desired unit (PSI, BAR, KPA,
kg/cm ). See Fig. 5.
•
Press “-” or “+” button to choose the desired value. Press and
hold “-” or “+” button will accelerate numerical change. After
system will enter the chosen unit.
•
Press the air pump’s On/Off button to start and hold this button
for continuous running. And the built-in LED light is lit during
inflation.
•
the Lock/Unlock switch upwards to lock while the On/Off button
is pressed. In
any button. To stop the inflation, simply press the On/Off button.
•
When the desired pressure is reached, the air pump will stop
running as it has pre-set function. when the desired pressure
2
The air pump has switch lock function. If needed, you can turn
