Page 26 of 113
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul
2
Nexus PRO™ User Guide
To configure the device in Link Aggregate Root Router Mode, follow these steps:
1. Go to Tools | System configuration drop down menu. The
System Configuration
will be
displayed as shown below.
2. Click on the
Device Mode
link in the
System Configuration
page.
3. Choose
the
Link Aggregate Root Router Mode
option and click on
Apply Changes
.
A
confirmation Wireless IP pop up window will appear as shown below.
4. After setting the wireless IP, click on
Apply Changes
. Please wait for the device to configure
the settings in the Link Aggregate Root Router Mode. Radio A and Radio B will now be in
Root Router Mode
5.
Both Radio A and Radio B need to be associated with the respective Radio A and
Radio B of the Remote Device, which should be configured in Link Aggregate Remote
Router/NAT Mode.
Note
: Ensure that both local and remote devices are enabled for Link Aggregate Mode.
Note
: When using Link Aggregate Root Router Mode, the Remote device should be configured in
Link Aggregate Remote Router/NAT mode.
When Configuring the IP address for Link Aggregate Root Router and Link Aggregate
Remote Router/NAT, you are required to assign the IP statically on both Root and Remote
sides.
The Wireless IP address on the Root and Remote devices needs to be
3 host addresses
apart
. The subnet mask cannot be less than 255.255.255.248.
For Example:
Root Router
is configured as:
192.168.1.208
(The following sequence
192.168.1.209
and
192.168.1.210
cannot be assigned to any other hosts)
Netmask:
255.255.255.0
Remote Router/NAT
needs to be configured as:
192.168.1.211
(The following sequence
192.168.1.212
and
192.168.1.213
cannot be assigned to any other hosts)
Netmask :
255.255.255.0
