Wiring and Operation
1.
Connect a jumper cable from the LNB/LNBF to the “TO LNB” connection
on the Satllite Finder.
2.
Connect the cable from your satellite receiver to the “TO REC” Input on the
Satellite Finder.
3.
Make sure your satellite receiver is on. The satellite Finder´s scale should be
lighted at this time and the meter reading should be around 2.
4.
Set your dish to the proper azimuth and elevation settings. (This information
should be supplied with your dish)
5.
Set the Satellite Finder´s scale reading to about 5 by adjusting the level
control found on the face of the Satellite Finder. (Turning the knob clockwise
will increase the reading.)
6.
Peak the signal by slowly moving the azimuth and elevation of your dish. If
the Satellite Finder´s reading becomes full scale, adjust the level control
knob to reduce the reading to around 5.
7.
Remove the jumper cable and Satellite Finder and reconnect the LNB/LNBF
to your receiver.