38
SMART LightRaise Installation and User's Guide
3
Use the hex security key to secure the two security screws.
Insert security
screws
4
Feed the cable ends that are hanging from the boom through a cable grommet at either
side or the top of the console. Leave the excess length of cable above the console.
5
Ensure the cables are bundled behind where the SMART Board interactive whiteboard will
be located. If you haven't already done so, use the provided tie wraps to loop the cables
into manageable (and fairly flat) bundles. Don't overlap the loops as this makes a thick
bundle that will push against the board.
Installing the Cable Cleats
The cable cleats provide a tidy storage location for the external computer cables.
Tools required:
Hardware required:
•
9
/
16
" wrench
•
cable cleats (from cable cleat accessory kit)
•
3
/
8
" nuts and washers
To install the cable cleats:
1
Insert each cable cleat bolt through a hole on the right side of the console.
2
Using the
9
/
16
" wrench, attach a
3
/
8
" nut and washer onto each cable cleat bolt protruding
inside the console.
Nuts
Cable Cleats
Cleat Hole
Cleat Hole