A P P E N D I X B
Connecting your room control system to your projector
86
smarttech.com/kb/170295
Field
Description
Cooling
The projector is cooling.
Confirm off
Confirm off
is a non-selectable power state that is returned during
stage one of the two-button
Off
sequence.
Idle
The projector is off but still receiving power (Standby mode).
Source selection controls
You can use source selection controls to switch input sources. The source type selected determines
which commands can be accepted.
The following commands inform you of the current source selection settings:
Command
Response
Available in Standby
mode
get input
input=[current selected projector
source input]
Yes
get videoinputs
videoinputs=[list of available projector
source inputs]
Yes
The following command controls the source selection settings.
Command
Command target range
Response
set input [target]
=vga1
=Composite
=HDMI
=Next
=None
input=[target]
The following table describes the source selection response fields.
Field
Description
VGA1
Switches source to the VGA 1 input connector.
Composite
Switches source to the Composite video connector.
HDMI
Switches source to the HDMI input port.
Next
Switches the input to the next possible source.
None
A non-selectable value that appears when you enter a “get input”
command while the projector is in Standby mode.
