INTRODUCTION
The SMT-AZC thermostat is designed
to work with the Smart Temp 24Volt
Zone Dampers
Please take time to read and
understand this manual so that
installation and testing is undertaken in
an efficient and effective manner.
Although great care has been taken in
the preparation of this manual, Smart
Temp takes no responsibility for errors
or omissions contained herein. It is the
responsibility of the installer to ensure
that this thermostat and the equipment
connected to it operate in a safe and
efficient manner.
Due to ongoing product improvement,
Smart Temp reserves the right to
change the specifications of the
SMT-AZC without notice.
All right reserved.
© Smart Temp Australia Pty Ltd
Intellectual rights apply.
DISASSEMBLY
Insert a small coin in the release slot
located on the bottom of the thermostat.
Gently twist the coin to release the
thermostat from the subbase. Avoid
twisting the case, as this may stress the
LCD and cause it to crack or bend the
terminal pin connectors.
TERMINAL DESIGNATIONS
The SMT-AZC has dedicated screw
terminals located on the subbase to
facilitate ease of wiring to the actuator
C
24 Volt Common
R
24 Volt Hot
PO
Power Open
PC
Power Close
DS
Duct Sensor
DS
Duct Sensor
Y
Not Applicable in Aust
W
Not Applicable in Aust
A
Modbus
B
Modbus
SMT-AZC SUBBASE
C R PO PC DS DS Y W A B
