Smart Technologies SMART Board 400iv, Configuration And User'S Manual

Page: 75 / 88

These commands control the current system settings. These commands are unavailable when the
projector is in Standby mode. See Value-based command methods on page 56 for setting absolute
and adjustment commands.
Command Command target range Response
set autosignal [target] =on
=off
autosignal=[target]
set lampreminder [target] =on
=off
lampreminder=[target]
set highbrightness [target] =on
=off
highbrightness=[target]
set autopoweroff [value] =0 to =240 autopoweroff=[value]
set zoom [value] =0 to =30 zoom=[value]
set projectorid [value] =0 to =99 projectorid=[value]
set hposition [value] =0 to =100 hposition=[value]
set vposition [value] =-5 to =5 vposition=[value]
set aspectratio [target] =fill
=match
=16:9
aspectratio=[target]
set projectionmode [target] =front
=ceiling
=rear
=rear ceiling
projectionmode=[target]
set startupscreen [target] =smart
=usercapture
=preview
startupscreen=[target]
A P P E N D I X A
Remotely managing your interactive whiteboard system
65