Smart Technologies SMART Board 2000i-DVS, Installation Manual

Page: 22 / 67

12 Setting Up Your 2000i
Turning on the 2000i
1. If the projector is not on, press the main power switch on the projector.
NOTE: The projector in the figure below is shown upside down, just as it’s installed in the
2000i.
2. Turn on the computer.
3. Turn on the projector lamp by pressing the Lamp On button on the control panel (to the right
of the pen tray).
The LED indicator beside this button flashes quickly for 60 seconds, and then remains steadily
illuminated when the projector lamp has powered up.
When an image displays, adjust the computer power settings and the image alignment on the
interactive screen. Then install SMART Board software, configure the COM port, and perform
a brief orientation procedure. All these procedures are described in
Finalizing the Installation
on page 21.
NOTE: You should leave the computer and the projector on at all times (so the projector is
either in use, with the lamp illuminated, or in standby mode). However, you can set the
computer to save power during periods of inactivity (see page 27 for details).
Main Power Switch
Lamp On
Button
On LED