7.2 Toggle Motor Power
As stated before, the indexing plunger let you park the Horizon Lite for give to you the
ability to work and set your monitor without adding an extra work to the motor while dealing
with monitor. In the case you want to power off the motor for any reason, you can do it by
just pushing the button
twice
. The system will be without motor feedback and you'll notice
that the system will be free to rotate.
In order to re-enable the motor, just push button twice again. The system will answer with
a fast blink and it will start moving the monitor to the "predefined" position.
VISUAL RECAP FOR MOTOR TOGGLE
If the motor is enabled:
User Interaction
PUSH
TWICE
THE BUTTON
Horizon Lite Acoustic Answer
QUICK BEEP AT EVERY BUTTON PUSH
Horizon Lite Command Execution
MOTOR DISABLE WITH
NO VISUAL FEEDBACK
If the motor is disabled:
User Interaction
PUSH
TWICE
THE BUTTON
Horizon Lite Acoustic Answer
QUICK BEEP AT EVERY BUTTON PUSH
Horizon Lite Command Execution
MOTOR ENABLE WITH
QUICK BLINK AS
VISUAL FEEDBACK. NO ACOUSTIC FEEDBACK
7.3 Angle Mode Setup
Sometimes, you could need to position the monitor to weird angle and you want that the
system will maintain that position regardless of the inclination of the sled.
To achieve this, just press the command button
three
times. After that, the system will alert
you to be entered in "Angle Mode Setup" with a low pitch beep and with a low speed
blinking of the multi-function button.
At this point, just roll the monitor to the desired position within 2 seconds and maintain it in
that position until the Horizon Lite will emit a new acoustic feedback.
The multifunction button will stop blinking and the Horizon Lite will maintain that angle as
"predefined" one.
Please note that the new angle is considered by the Horizon
Lite, the new “predefined” one. Even a complete Power
Cycle or a Motor Toggle ON/OFF will not cancel this new
setup.
To re-establish the default Horizon Litetal Mode just read
the paragraph 6.3
20
Summary of Contents for SMARTCAM HORIZON LITE
Page 1: ...1 v 1 2 ...
Page 5: ...5 SmartCAM Horizon Lite Overview 5 ...
