-10-
Note:
This Smart Lifter opener is supplied with the
transmitters already coded (depending on country).
Please test all transmitters to confirm that they are coded
prior to starting Step 8.1.
8.1) Press CODE until the LED displays (
.
). Press a
button on the transmitter, the LED dot will turn off.
Release and press the same button again, the dot
will flash to confirm the code.
8.2) Repeat step 8.1 to code a maximum of 20 different
transmitters and/or buttons.
8.3) To delete all stored codes, press and hold CODE
for 8 seconds until LED dot turns off, all stored
codes have now been deleted.
Maintenance
No particular maintenance is required for the logic circuit
board.
At least twice a year check that the door is properly
balanced and that all working parts are in good working
condition.
IMPORTANT:
A poorly operating door can effect the life of
the automatic opener due to incorrect loads and will void
the warranty.
Check the reversing sensitivity at least twice a year and
adjust if necessary.
Make sure that the safety devices are working effectively
(photo beams, etc.)
Final Notes
This manual is only for use by technical personnel
qualified to carry out the installation.
No information given in this manual can be considered of
any interest to the end user.
No setting or adjustments contained in this manual
should be carried out by the end user.
It is important for the installer to show their clients correct
operational use of the Smart Lifter including the use of
the manual disengagement cord.
Inform the owner about the need for regular and accurate
maintenance, especially regarding a regular check of the
safety and reversing devices.
Coding Transmitters
Technical Specifications
Power Input:
240 VAC ±10% 50Hz
Motor:
24V DC 100W
Courtesy light time:
3 mins
Working temperature: -20° ~ 70°C
Relative Humidity:
<90%
Open and close force: 600N
Reception frequency: 433.22MHz
Sensitivity:
>1V for correct receiver signal
(average range 50m, with an
aerial)
Decoding:
Rolling code
Transmitter power:
23A 12V Battery
Globe:
24V 21W Automotive type
(availalble from most car
accessories stockists)
NOTE: Smart Openers Pty Ltd reserves the right to
modify its product and product specifications at any
time without prior notice.
Typical Application
The Smart Lifter (max. 2500mm travel) model can
automate sectional overhead doors up to a height of
2600mm and tilting overhead doors up to 2600mm.
smart
openers
TX CODE ACTIVE
