11
3.4 Pairing Handset & Door Bell
The SMARTENTRY system has been setup and paired for you. However, should you purchase
any additional handsets or monitors or need to pair them again, please follow the steps below.
Clear Pairing Code (Handset)
1. Make sure the handset has at least 50% battery. The handset will need to either be in the
charging station, or powered by USB to enter the menu.
2. Press the button to enter the ‘Options’ menu and then press the or buttons to go
to the clear code menu. Then, press to confirm the ‘CLEAR CODE’ command.
3. Input the correct password (Default is 0000) by using the or buttons. When entering
the password, press the to move position.
4. Press the button to confirm clear code.
5. Once the screen displays ‘Clear code succeeded’, move on to the next section.
Clear Pairing Code (Outside Camera Unit)
1. Use the allen key found in the bottom of the charging station and remove the bottom panel from
the outside unit.
2. Remove the battery box.
3. Use the top of the allen key to press and hold the ‘Clear Code’ (shown on page 9) button for
about 10 seconds. At the same time, put the battery box back into the unit.
4. Keep the button pressed until you hear 2 double beep sounds and then you can release the
button.
5. After releasing the button, wait until the outside camera unit beeps 3 times. When it has done
this, you can move on to the next section.
