SMART Embedded Computing RTM-ATCA-F140 Series, Installation & Use Manual

Page: 75 / 82

RTM-ATCA-F140-D Information
RTM-ATCA-F140 Series Installation and Use (6806800M97M) 75
A.2.1 RTM Installation
Care should be taken when installing the RTM-ATCA-F140-D. The upper and lower
handles are different due to the location of the captive screw on the front panel of the RTM.
NOTE: The ATCA-F140-D front blade must be installed in the system before the RTM
installation so that the captive screw can be engaged with the Zone 3 attachment
block on the front blade.
Refer to the following procedures and figures for the RTM-ATCA-F140-D installation. Refer
to
Section 2.4.2 on page 48
for additional RTM installation and removal procedures. More
detailed installation instructions can be found in the
AXP1440-D Installation and Use
manual. Refer to
Appendix B, Related Documentation on page 79
.
Installation Procedure
1. Make sure that the upper handle is in the outward position by squeezing the lever and
the latch together. Check that the lower handle is in the open position.
2. Insert the RTM into the shelf by aligning the top and bottom edges of the RTM in the
shelf’s card guides.
To prevent damage when installing an RTM and an AdvancedTCA blade in a
ruggedized system, first install the AdvancedTCA blade, then install the matching
RTM.
Figure A-3 Upper and Lower Handles
Lever
Latch