Receiver Panel
1)
DC input port- The 5V DC is the power input for the receiver
2)
HDBaseT port-This is the Cat5e cable connection between the two units.
A:yellow LED-The LINK LED indicates that an HDBaseT link connection has been
established between the two boards over the Cat5e cable.
B:green LED-
a.When the LED is on, it indicates that video content with HDCP protection is being
transferred.
b.When the LED is blinking, it indicates that video content without HDCP protection
is being transferred.
c.When the LED is off, it indicates that no video is being transferred.
3)
RS232 – This connector has a dual purpose
A:In its default mode, it may be used for serial RS232 data transfer over the
HDBaseT link
B:When connected to a user’s PC it serves as a debug interface(See Update
instruction)
4)
LED Indicators:status–when blinking indicates the device is active.
5)
LED Indicators:Power–The PWR LED indicates that power is available to the unit.
6)
IR-RX port - This jack can be used for connecting IR-RX cable.
7)
IR-TX port - This jack can be used for connecting IR-TX cable.
8)
HDMI Output port
9)
Ethernet port–Reserve.
5
Operating Instructions
Connection Diagram
Application
CONNECTING AND OPERATING
1)
Connect the HDMI signal source (Such as DVD, STB etc) to HDMI Transmitter.
2)
Connect cat5e/6 cables to both HDBaseT port of the transmitter and HDBaseT port
of the Receiver.
3)
Connect the HDMI output (Such as HD-LCD, HD-DLP) into the Receiver.
4)
Connect the IR-TX cable into transmitter IR-TX port on the back panel and affix the
emitter onto the source IR windows ,Connect the IR-TX cable into receiver IR-TX port on
the back panel and affix the emitter onto the sink IR windows.
5)
Connect the IR RX receiving cables into IR-RX port of receiver, and affix the IR RX
near or on the video Display frame or stand within direct line of sight with the hand held
remote, connect the IR-RX cable into the transmitter to control the sink.
6)
Turn on all devices.
Attention: Insert/Extract cables gently.
