Install monitor and
tension the hinge
iLid™ is tensioned at the factory for a 12-15 lb. monitor. If you
need to make a tension adjustment for smooth operation of
the iLid, use a 5/32” hex key and 7/16” open end wrench to
tighten or loosen the adjustment on the left bracket. The
right bracket has the spring to assist opening. The friction
adjustment of the left bracket provides damping so the lid
doesn’t open with too much force and bounce the monitor
around.
You will need to remove the monitor to make this adjustment. Be careful when opening the iLid
without a monitor installed. If the spring tension does not have any friction resistance, the lid
will open too fast and the forces could tear the lid from the mounting screws. If this happens,
use a wooden toothpick and wood glue to repair the mounting hole.
Finishing the installation
Put the table on the floor on its feet or casters. If you installed a CPU
holder, such as the EZ Cinch or Brig, the bracket for this has been
installed over the leg bracket. The CPU can be installed according to
the directions that came with the CPU holder.
iLid® Table Instructions ©2018 CBT Supply, Inc.
7
Technical Support: 800-770-7042
