SMART Board SPNL-6065-V2 Quick Start Quide Download Page 3

1029972 Rev 01

 3

Federal Communication Commission interference statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not 

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 

undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC 

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. 

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following 

measures:

•  Reorient or relocate the receiving antenna. 
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
•  Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: 

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s 

authority to operate this equipment.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be 

installed and operated with minimum distance of 20cm between the antenna and all persons.   

NOTE:

 This product has been configured to operate according to the FCC rules in the US.  

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.  5.15–5.25 GHz 

frequency band operation is restricted to indoor use only. Outdoor operations in the 5150~5250 MHz are prohibited.

Industry Canada statement:

This device complies with RSS-210 of the Industry 

Canada Rules. Operation is subject to the following 

two conditions: (1) This device may not cause harmful 

interference, and (2) this device must accept any 

interference received, including interference that may 

cause undesired operation.

Caution:

(i)  the device for operation in the band 5150-5250 

MHz is only for indoor use to reduce the potential 

for harmful interference to co-channel mobile 

satellite systems;

(ii)   the maximum antenna gain permitted for devices 

in the bands 5250-5350 MHz and 5470-5725 

MHz shall comply with the e.i.r.p. limit; and

(iii)  the maximum antenna gain permitted for devices 

in the band 5725-5825 MHz shall comply with the 

e.i.r.p. limits specified for point-to-point and non 

point-to-point operation as appropriate.

(iv) Users should also be advised that high-power 

radars are allocated as primary users (i.e. priority 

users) of the bands 5250-5350 MHz and 5650-

5850 MHz and that these radars could cause 

interference and/or damage to LE-LAN devices.

Radiation Exposure Statement:

This equipment complies with IC radiation exposure 

limits set forth for an uncontrolled environment. This 

equipment should be installed and operated with a  

minimum distance of 20 cm between the antenna and 

all persons.

Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada 

applicable aux appareils radio exempts de licence.  Son fonctionnement 

est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas 

produire de brouillage préjudiciable, et (2) ce dispositif doit accepter 

tout brouillage reçu, y compris un brouillage susceptible de provoquer 

un fonctionnement indésirable. 

Avertissement:

Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des 

instructions précises sur les restrictions susmentionnées, notamment :

(i)   les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont 

réservés uniquement pour une utilisation à l’intérieur afin de réduire 

les risques de brouillage préjudiciable aux systèmes de satellites 

mobiles utilisant les mêmes canaux;

(ii)  le gain maximal d’antenne permis pour les dispositifs utilisant les 

bandes 5 250-5 350 MHz et 5 470-5 725 MHz doit se conformer à 

la limite de p.i.r.e.;

(iii)  le gain maximal d’antenne permis (pour les dispositifs utilisant la 

bande 5 725-5 825 MHz) doit se conformer à la limite de p.i.r.e. 

spécifiée pour l’exploitation point à point et non point à point, selon 

le cas.

(iv)  De plus, les utilisateurs devraient aussi être avisés que les 

utilisateurs de radars de haute puissance sont désignés utilisateurs 

principaux (c.-à-d., qu’ils ont la priorité) pour les bandes 5 250-5 350 

MHz et 5 650-5 850 MHz et que ces radars pourraient causer du 

brouillage et/ou des dommages aux dispositifs LAN-EL.

Déclaration d’exposition aux radiations:

Cet équipement est conforme aux limites d’exposition aux 

rayonnements IC établies pour un environnement non contrôlé.  

Cet équipement doit être installé et utilisé avec un minimum de  

20 cm de distance entre la source de rayonnement et votre corps.

Reviews: