A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
71
Setting
Use
Notes
Image
Alignment
Screen
Enables you to adjust the
projected image size, shape
and location.
The image alignment screen appears the first
time you start your projector. However, you
can access it from the startup screen menu
any time. Press
Menu
or
Enter
to close it.
Set to Default?
Resets projector settings to
their default values.
If you select
Yes
, all projector settings reset to
their defaults, reversing any menu changes
that you made. This action is irreversible.
Don’t adjust this setting unless you want to
reset all of the applied settings, or unless
you’re advised to by a SMART Support
specialist.
USB Source
Select
Opens a sub-menu that
enables you to select the
video input on your projector
and the USB port on the
ECP (if present).
The defaults are as follows:
l
HDMI 1, USB 1
l
HDMI 2, Disabled (no associated USB
input)
l
VGA 1, USB 2
Network menu
Network
Activates the projector’s
RJ45 connector and network
features.
Status
Displays the current network
status (
Connected
,
Disconnected
or
Off
).
The default is off.
DHCP
Displays the status of the
network’s Dynamic Host
Configuration Protocol
(DHCP) as
On
or
Off
.
The default is on.
On
enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off
enables an administrator to assign an IP
address manually.
Password
Reminder
Emails the network
password to the previously
defined email recipient.
See
on page 43 to set
up a destination email address.
IP Address
Displays the projector’s
current IP address in values
between 0.0.0.0 and
255.255.255.255.
To change the projector’s IP address, use the
RS-232 connector (see
page 63) or use a DHCP server to assign a
dynamic IP address and then set a static IP
address using the network remote
management feature (see