SMART Board M685ix2, Configuration And User'S Manual

Page: 71 / 98

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
63
Network controls
These commands control the integration properties of the projector.
Usable command
by power state
Property Valid values Notes
Standby
/ idle
On
set or get network
• on
• off (default)
Enables or disables the
network module.
set or get set or get vgaoutnetenable
• on
• off (default)
Same function as the
“network” property.
get get netstatus
• connected
• disconnected
• disabled
Reports whether the
network port on the
projector is connected to a
network or not.
set or get set or get dhcp
• on
• off (default)
When off, the projector's
network IP address,
subnetmask, gateway and
primary DNS values must
all be set manually.
set or get set or get ipaddr A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
set or get set or get subnetmask A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
set or get set or get gateway A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
set or get set or get primarydns A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
get set or get macaddr xx-xx-xx-xx-xx-xx] The media access control
(MAC) identifier of the
projector’s network
module.