These commands control the current system settings. These commands are available when the
projector is in Standby mode and when it is on.
Command
Command target range
Response
set restoredefaults
[none]
restoredefaults=done
set lamphrs [target]
=0
lamphrs=0
set vgaoutnetenable [target]
=on
=off
vgaoutnetenable=[target]
set usb1source [target]
=vga1
=vga2
=hdmi
=disabled
usb1source=[target]
set usb2source [target]
=vga1
=vga2
=hdmi
=disabled
usb1source=[target]
T
T I P
The
set usb1source
and
set usb2source
commands are only applicable to SMART UX60
projectors running DLP firmware version 1.0.0.4 or later.
N
N O T E
The
Network and VGA Out
setting’s features are off by default. Select
on
to activate these
features.
A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
75