HARDWARE INSTALLATION
1.
Position the E300 conveniently and keep it unplugged.
2.
Connect the E300 HDMI IN connector to an HDMI Source.
3.
Optionally connect a VGA or HDMI display to the E300 VGA or HDMI OUT connector for local
monitoring of the streaming video signal and power on the display.
4.
Connect the RJ45 LAN port on the E300 to your network.
5.
Power on the E300 Encoder and wait a few seconds for the unit to initialize.
6.
Use the SaviStreamer software to identify the IP address of the E300 and make note of it.
Further instructions on this will be located below in the SaviStreamer software section.
7.
Power off the E300.
8.
See the D300 Decoder documentation to set up the decoder at this point. When the D300 is
ready, continue with the next step.
9.
Power on the E300 Encoder and wait a few seconds for the unit to initialize.
10.
Power on the connected video source and start streaming to the E300.
11.
If needed, power cycle or reboot the D300 Decoder to start displaying the video stream.
Summary of Contents for SaviStreamer E300
Page 1: ......
