HDR 8X8 Rear View
USING THE FRONT PANEL CONTROLS
During normal operation, you will see a list of ports on
the front panel display.
To assign an output to an input, press [SWITCH]. A
blinking block cursor will appear. Use [UP] and
[DOWN] to select the input that you would like to as-
sign. Once the cursor is over the desired input port,
press [ENTER] to enter editing mode. Press [UP] and
[DOWN] to select the output port. Once you have se-
lected an output, press [ENTER] to save the configura-
tion. To escape from editing mode, press [ESC].
Because HDCP takes time to negotiate, when switch-
ing ports, wait 2 seconds for the process to complete.
Failure to do so may cause an error with the HDCP
and the HDR-8X8 may lock up.
NOTE: To lock the front panel buttons to avoid any
accidental changes, press [ESC] + [MENU] + [ENTER]
+ [SWITCH] at the same time. The display will indicate
that it is locked. Repeat the procedure to unlock the
front panel.
INTRODUCTION
The HDR 8x8 conforms to the HDMI standard and
provides a connection to view any eight HDMI video
sources on any combination of eight video displays.
The matrix configuration allows switching between
any HD source and/or display. The HDR 8x8 provides
HDMI output up to 20 feet and at HDTV resolutions
up to 1080p.
HARDWARE INSTALLATION
1. Turn off all input devices and displays.
2.
Connect the input devices to the “IN” ports on the HDR
-8X8
3.
Connect the displays to the “OUT” ports on the HDR
-8X8.
4. Connect the power cord and power-on the HDR-8X8.
5. Power on the input devices and the displays.
NOTE: Each input and output can support up to 10mA/5VDC. Do not connect extenders that are powered by HDMI.
