SMAR TT302, Installation, Operation & Maintenance Instruction Manual

Page: 21 / 44

Configuration
3-3
Sensor Configuration
It is necessary to configure the transducer number allocated to its task. The parameter
SENSOR_TRANSDUCER_NUMBER should be configured to 1.
Figure 3.2 - Temperature Calibration - TT302
It is possible to configure connection and sensor type by means of parameters
SENSOR_TYPE and SENSOR_CONNECTION. The connection and sensor types
available are listed in the tables
Table 3.1 - Sensor Type Table and Table 3.2 - Type of
Connection Table , as well as the corresponding value.
Figure 3.3 - Temperature Calibration - TT302
NOTE
There are no 3 or 4 wire connections for mile-voltage sensors.
This parameter could
be 1 or 2, for indicating
respectively first or
second transducers. This parameter
sets the transducer
number, according
to the type of
temperature
measurement.
TT2EM302.CDR
This list contains:
Thermocouples,
RTDs, Ohm and
Milivoltage.
This parameter
selects the type of
sensor attached to
the
TT302 in order
to measure
temperature.
TT2EM303.CDR