7.3 Washer Overflowing (Water fills not stop)
The most common part(s) or condition(s) which contribute to the
symptom Washer overflowing are listed below. Check or test each item.
If you are still unable to solve the problem you may need to do
additional research and troubleshooting.
Causes
Explanation
Water inlet valve
If the washer is overflowing and power is shut off to
the washer, the water inlet valve has failed. Replace it.
Water level sensor or
control switch
A water lever control switch controls how much water
enters the washing machine by PCB. If the water level
control switch is defective, or more commonly, if the
small air pipe attached to the air bell comes off, there
will no longer be pressure in the hose pushing on the
air tight diaphragm in the water level control switch.
The switch will not be able to open the electrical
contacts to the washer fill valve.
CHECK THE AIR PIPE
CHECK THE WATER LEVERL SENSOR
CHECK THE PCB and the inner wire between PCB and
the sensor
21
7 TROUBLESHOOTING