SMA MULTICLUSTER-BOX 12, Operating Manual

Page: 8 / 54

2 Safety SMA Solar Technology AG
Operating manual MC-BOX-12-3-20-BE-en-13 8
Any use of the product other than that described in the Intended Use section does not qualify as the intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a convenient, dry place for
future reference and observe all instructions contained therein.
This document does not replace and is not intended to replace any local, state, provincial, federal or national laws,
regulations or codes applicable to the installation, electrical safety and use of the product. SMA Solar Technology AG
assumes no responsibility for the compliance or non-compliance with such laws or codes in connection with the
installation of the product.
The type label must remain permanently attached to the product.
2.2 IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This section contains safety information that must be observed at all times when working on or with the product.
The product has been designed and tested in accordance with international safety requirements. As with all electrical
or electronical devices, there are residual risks despite careful construction. To prevent personal injury and property
damage and to ensure long-term operation of the product, read this section carefully and observe all safety
information at all times.
DANGER
Danger to life due to electric shock when live components or cables are touched
High voltages are present in the conductive components or cables of the product. Touching live parts and cables
results in death or lethal injuries due to electric shock.
• Do not touch non-insulated parts or cables.
• Disconnect the product from voltage sources and make sure it cannot be reconnected before working on the
device.
• Only disassemble the protective covers, if the product is disconnected from all voltage sources.
• Wear suitable personal protective equipment for all work on the product.
CAUTION
Risk of injury if the product tips over
The product is heavy and may tip over if not properly fastened to the support surface. This can result in crushing
injuries.
• Upon installation, attach the product to the support surface.
CAUTION
Risk of burns due to hot components
Some components and terminals inside the product can become hot during operation. Touching hot components or
terminals can result in burn injuries.
• Wear suitable personal protective equipment for all work on the product.
• Only operate the product with its protective cover mounted.
• Prior to removing the protective cover, let the product cool down.